HPE0-J50試験無料問題集（70題）「HP Integrating Protected HPE Storage Solutions 認定」

出題：1

Refer to the exhibit.

An Integrator is configuring File Persona on a HPE 3PAR StoreServ 8440.
What is a valid Netmask for the configuration shown?

A. 255.255.255.0

B. 172.27.97.61

C. 255.255.252.0

D. 172.20.0.0

正解：A 解答を投票する

出題：2

An HPE StoreVirtual 3200 system consists of 19x 1.2 TB Drives in a RAID5 with a capacity level of 75%.
The network is built with four HPE FlexFabric 5900 switches.
The customer complained about performance challenges with the given configuration, and the administrator identified the drive configuration as a bottleneck. A performance analysis shows latencies above 60ms.
Installation of the systems was done by best practices.
Which actions should be performed to solve these issues? (Choose two.)

A. Offer SSD drives for tiering purposes and a performance boost.

B. Advise additional tiering licenses.

C. Change RAID set to RAID 1 on both systems.

D. Verify that a minimum of 4 RAID sets are built for optimal performance.

E. Set the bonding policy to ALB on both systems.

正解：A,D 解答を投票する

出題：3

A storage integrator is handing over an installed HPE StoreOnce solution to the customer and demonstrates that the system is property configured.
Which CLI command can be used to run an appliance self-test?

A. system confidencechecker runtest all

B. confidencecheck

C. run confidencereport

D. run confidencereport all

正解：A 解答を投票する

出題：4

Click the menu option a storage integrator will use to install a new StoreOnce VSA solution.

正解：

Explanation

References:

出題：5

As a best practice, what should the Integrator do after finishing a storage solution installation?

A. Verify the event logs are accumulating data.

B. Test storage solution functionality under the operational temperature range.

C. Verify the used space in a rack.

D. Remove and insert each hot swappable component one-by-one.

正解：B 解答を投票する

出題：6

A storage integrator is planning the implementation of a single HPE StoreOnce 3100.
How many power cords are required to be connected to PDU from this storage system, when power supply kit was ordered?

A. 2

B. 4

C. 6

D. 0

正解：A 解答を投票する

出題：7

Refer to the exhibit.

Which command can be used in the CLI console to set the static IP address and DNS server for an HPE StoreOnce device?

A. run setup

B. setup network

C. create network

D. net set wizard

正解：D 解答を投票する

HPE0-J50試験無料問題集「HP Integrating Protected HPE Storage Solutions 認定」