3601試験無料問題集（70題）「Avaya Virtual Services Platform 9000 Maintenance and Troubleshooting 認定」

出題：1

With an ACL being identified by a unique system wide ACL ID in the range of 1-2048, what does the number 2048 represent?

A. the maximum enabled ACLs for the VSP 9000

B. the maximum supported ACLs for the network

C. the maximum supported ACLs for the VSP 9000

D. the maximum supported ACLs and ACEs for the network

正解：C 解答を投票する

出題：2

Given the following command:
clear ports states | error: [<ports>\]
What can be done with this command?

A. Produce error statistics on a givenport.

B. Stop port monitoring.

C. Start error monitoring.

D. Reset the counters.

正解：D 解答を投票する

出題：3

The Routing Table Manager (RTM) is a software module within the VSP 9000. It produces the routing table for each Virtual Routing and Forwarding (VRF).
Which statement describes a significant function of the RTM?

A. It determines any necessary link operation/configuration changes.

B. It predicts necessary changes to configurable route preferences.

C. It ignores static routes for efficiency.

D. It maintains the routing tables by interacting with the routing protocols for each VRF.

正解：D 解答を投票する

出題：4

How can configuration redundancy be achieved on a VSP 9000?

A. Partition the system flash memory to provide two copies.

B. Define the primary and backup configuration file paths.

C. Define the secondary and tertiary backups to the primary configuration file path.

D. Use two Compact Flash (CF) cards, one mirroring the other.

正解：B 解答を投票する

出題：5

During a VSP 9000 boot up, the following log message appears: "Powering off card in slot 12 due to a low power condition."
Which statement describes how that card is brought back in service?

A. Configure the existing power distribution to send enough power to that card.

B. Re-direct power to that card from one of the spare SFmodules.

C. Change the card's priority assignment for the power-down algorithm.

D. Add more power to the chassis.

正解：C 解答を投票する

出題：6

Given the following command:
show ports error show-all [file <value>\]
What kind of information does this command produce?

A. collisions

B. flapping ports

C. disabled ports

D. improper port assignments

正解：A 解答を投票する

出題：7

Which statement describes a valid guideline for proper operators of Border Gateway Protocol (BGP) on a VSP 9000?

A. Ensure the routers that need DGP to operate are in forwarding mode.

B. If Open Shortest Path First (OSPF) is the Interior GatewayProtocol (IGP), use a new OSPF tagconstruction.

C. Use the max-peer-route parameter to limit the number of routes BGP imports from a peer.

D. For routers that support both BGP and OSPF, the OSPFrouter ID and the BGP identifier must be configured to different IP addresses.

正解：A 解答を投票する

3601試験無料問題集「Avaya Virtual Services Platform 9000 Maintenance and Troubleshooting 認定」