3605試験無料問題集（173題）「Avaya Ethernet Routing Switch Implementation and Maintenance 認定」

出題：1

The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network. HMD primary benefits of this design goal? (Choose two)

A. The architecture provides high performance Layer 3 switching, resiliency, security, and services.

B. The ability to provide hitless software upgrades for the core of the network.

C. in the event of a failure, no loss of connectivity or application availability will be experienced by the end user

D. This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS) and 10 gigabit Ethernet.

正解：B,C 解答を投票する

出題：2

Refer to the exhibit.
Virtual Link Aggregation Control Protocol (VLACP) is configured by port, and traffic is only forwarded across the uplinks when VLCAP is up and running correctly. A = InterSwitch Trunk (IST) B = SplitMulti-Link Trunk (SMLT) #1 ERS 8600 #2 ERS 8600 #3 ERS 4500 When configuring VLCAP for the network shown in the exhibit, where should it be configured?

A. On all SMLT links and one of the IST links.

B. On all IST ports and not SMLT ports.

C. On none of the IST or SMLT links depicted in this network.

D. On all IST and all SMLT ports.

正解：D 解答を投票する

出題：3

Auto-negotiation should be enabled on all ports except under which condition?

A. When there are fiber ports in some end workstations

B. When there is a mix of 10 Mops and 1 Gbps end servers

C. When only the core Pitches support auto-negotiation

D. When there is a mix of R and RS modules in the stack

正解：C 解答を投票する

出題：4

An Ethernet Routing Switch (ERS) 8600 is being configured for Virtual Router Redundancy Protocol (VRRP). If the default value is used on the peer switch, which CLI command would cause this switch to e the VRRP master?

A. Config vlan 100 ip vrrp 100 priority master

B. Config vlan 100 ip vrrp 100 priority 250

C. Config vlan 100 ip vrrp 100 master

D. Config vlan 100 ip vrrp 100 priority 1

正解：B 解答を投票する

出題：5

What is the front panel port configuration for the Ethernet Routing Switch (ERS)
2550T-PWR?

A. 48 10/100 BaseT ports (PoE on 48 ports) Two combo 10/100/1000BaseT or SFP port

B. 50 10/100BaseT ports (PoE on 25 ports) two combo 10/100/1000BaseT or SFP port

C. 48 10/100BaseT ports (PoE on 24 ports) two combo 10/100/1000BaseT or SFP port

D. 50 10/100BaseT ports (PoE on 50 ports) two combo 10/100/1000BaseT or SFP port

正解：C 解答を投票する

出題：6

Routed Split Multilinking Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN by
adding router redundancy. RSMLT
is configured on which Ethernet
Routing Switch (ERS) configuration component?

A. an SMLT

B. an OSPF router

C. a VLAN

D. a core switch port

正解：B 解答を投票する

出題：7

On the Ethernet Routing
Switch (ERS)
8800, the Virtual Routing
Forwarding (VRF)-Lite feature supports multicast virtualization. Which statements about multicast virtualization are true? (Choose two)

A. Multicast virtualization is fully supported in high availability mode and there is no interruption to traffic in the event of the failure of a CPU.

B. Multicast virtualization requires version 7.1 or later.

C. Many IGMP and PIM commands that you use on the Global Router also apply to VRFs that create.

D. To facilitate multicast route redistribution between VRFs, an external unicast edge router is required.

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：8

When configuring an Ethernet Routing Switch (ERS) 8600 redundant Installation for warm standby, which protocol is used to give the fastest recalculation of large layer 3 topology by the standby CPU, after a Master CPU failure?

A. Rip

B. STP

C. BGP

D. OSPF

正解：D 解答を投票する

出題：9

The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a Virtual Route Redundancy Protocol (VRRP) address was not successful. What is causing this problem?

A. The data center interface is set as a critical IP interface.

B. The virtual router identifier is configured for the VRRP IP address owner.

C. The virtual router identifier is 0.

D. A real IP address is required for management access not a VRRP address.

正解：D 解答を投票する

出題：10

What is a characteristic
of Routed Split Multi-Link Trunking (RSMLT)
configuration?

A. RSMLT is only configured on edge SMLT connections.

B. RSMLT routers are implemented with Virtual Routing Forwarding (VRF)-Lite routers.

C. RSMI T uses priority values to distinguish between the primary and backup routers.

D. RSMLT is always used in conjunction with routing protocols and SMLT connections.

正解：D 解答を投票する

3605試験無料問題集「Avaya Ethernet Routing Switch Implementation and Maintenance 認定」