200-401試験無料問題集（64題）「Cisco Managing Industrial Networks with Cisco Networking Technologies 認定」

出題：1

You are a called upon to troubleshoot connectivity problems to a network device on a production floor. You have used ping and traceroute to verify that you cannot connect to the device from the management network. The network is 209.165.202.128/27 and the device has been given the IP address 209.165.202.158 and mask 255.255.255.224. You have verified that you can reach the device with your computer connected to the same switch as the device. What could be the cause of this problem?

A. The device is set to the wrong subnet mask.

B. The device is connected to a switchport in the wrong VLAN.

C. The device has no IP default gateway.

D. The device is set to the wrong IP address.

正解：C 解答を投票する

出題：2

The network administrator is using a Windows PC application that is called putty.exe for remote communication to a switch for network troubleshooting. Which two protocols could
be used during this communication? (Choose two).

A. RMON

B. SNMP

C. Telnet

D. SSH

E. HTTP

正解：C,D 解答を投票する

出題：3

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?

A. SSH requires fewer network resources and no additional configuration.

B. Telnet is more difficult to use and configure than SSH.

C. Telnet encrypts only the login information, not the entire transmission.

D. SSH encrypts the login and session information.

正解：D 解答を投票する

出題：4

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

A. BDPU priority

B. root bridge

C. fast mode ports

D. designated ports

E. root ports

F. duplex operating mode

正解：B,D,E 解答を投票する

出題：5

How does the optical time domain reflectometer use "backscattered" light to make measurements?

A. It measures light-pulse width to measure that all pins are correctly connected.

B. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.

C. It performs wiremapping to measure that all pins are correctly connected.

D. It correlates the returned light pulses with a location in the fiber.

正解：D 解答を投票する

出題：6

At which Layer would you check for spanning tree loops?

A. Layer 4

B. Layer 3

C. Layer 1

D. Layer 2

正解：D 解答を投票する

200-401試験無料問題集「Cisco Managing Industrial Networks with Cisco Networking Technologies 認定」