642-035試験無料問題集（168題）「Cisco Troubleshooting Cisco Data Center Unified Computing 認定」

出題：1

Which three Cisco UCS server components can be upgraded via a host firmware package? (Choose three.)

A. adapter

B. Cisco IMC

C. Cisco UCS Manager

D. I/O module

E. board controller

F. BIOS

G. fabric interconnect

正解：A,E,F 解答を投票する

出題：2

Which four tasks can be performed via Cisco IMC remote access to a Cisco UCS system? (Choose four.)

A. configure the boot order

B. toggle the locator LED

C. view properties and sensors

D. deploy an operating system

E. power cycle the server

F. enable Cisco UCS Manager

G. configure the hypervisor

正解：A,B,C,E 解答を投票する

出題：3

A customer has Server1 working properly, configured to boot over SAN and with service profile SP1 assigned. This service profile is cloned to service profile SP2 and assigned to
Server2. Before Server2 boots, which three actions needs to be performed? (Choose three.)

A. Check the WWPN that is assigned to the vHBAs on SP2.

B. Add two vHBAs and assign them to the proper VSAN.

C. Check the MAC address that is assigned to the vNICs on SP2.

D. Add the pWWN of SP2 to the zoning on the SAN switch.

E. Change the IP address of the vNICs.

F. Change the boot target on SP2.

正解：A,D,F 解答を投票する

出題：4

When should an operating system driver be installed or updated?

A. when you connect the new storage system

B. after reviewing the Cisco UCS B-Series Hardware and Software Interoperability Matrix and reacting accordingly

C. during an operating system update

D. during a Cisco UCS firmware update

正解：B 解答を投票する

出題：5

You are attempting to install Microsoft Server 2008 R2 on a Fibre Channel LUN, but the installer does not see the LUN. You have used F6 to load the appropriate SCSI driver. What should your first troubleshooting step be?

A. Validate that the Fibre Channel uplink from the fabric interconnect is up.

B. Email the SAN administrator to validate that your LUN is defined.

C. Check the configuration of the vHBA in the service profile.

D. Validate zoning on the Fibre Channel switch.

E. Validate that the boot order is correct.

正解：C 解答を投票する

出題：6

Which two statements about the Cisco UCS FSM are true? (Choose two.)

A. Cisco UCS has two FSMs.

B. The FSM is run on the DME.

C. The FSM is used to observe the physical, logical, and virtual components on the Cisco UCS.

D. The FSM is a workflow model with a finite number of stages.

E. The FSM is a process to upgrade the firmware.

正解：B,D 解答を投票する

出題：7

At any given time, each server can be associated with how many service profiles?

A. 2

B. 1

C. 5

D. 10

E. unlimited

正解：B 解答を投票する

出題：8

You upgrade an operating system on a Cisco UCS C-Series Rack Server. After the upgrade, you discover that the performance of the server is much slower than expected. You verify that the operating system is on the Cisco support matrix for the rack server. Which two firmware types are the possible cause of the performance issue? (Choose two.)

A. vSwitch

B. fNIC

C. mptspi

D. vNIC

E. eNIC

正解：B,E 解答を投票する

出題：9

A UCS Admin is trying to launch the KVM console but it is failing to launch. All IP Pools for mgmt are configured and the CIMC has an address in UCSM. They SSH to the fabric Interconnect and run an ethanalyzer while issuing a ping from their local PC to the KVM IP address. The ping is successful but they do not see the ICMP requests and replies displayed in the capture. Here is the filter they used:
FIA(nxos)# ethanalyzer local interface mgmt display-filter icmp limit-captured-frames 0
What could be the reason pings are not seen in the capture and the KVM is failing to load?

A. Java settings are preventing the KVM from loading

B. There is a duplicate IP address for that CIMC address

C. The CIMC IP pool is in the same subnet as the Fabric Interconnects mgmt 0 interface

D. The switch upstream from the FI has the wrong vlan configured

正解：B 解答を投票する

出題：10

While performing an upgrade to Cisco UCS Release 2.2, the traffic in several VLANs is no longer active. What is the cause of this issue?

A. Ethernet and FCoE VLANs cannot be configured on the same Cisco UCS domain.

B. The UCS Manager detected overlapping VLANs during the upgrade, and Ethernet traffic on those VLANs is now dropped.

C. Ethernet and FCoE VLANs cannot be configured different Cisco UCS domain.

D. The UCS Manager needs to be rebooted to force the configuration to work properly.

正解：B 解答を投票する

642-035試験無料問題集「Cisco Troubleshooting Cisco Data Center Unified Computing 認定」