DES-3128試験無料問題集「EMC Specialist - Implementation Engineer, NetWorker 認定」

Which technology is used for backup and recovery with NMM?

解説: (GoShiken メンバーにのみ表示されます)
An administrator wants to use block-based backups on a Windows client. They have already installed the NetWorker client software package on the system Which statement describes the need for an additional NetWorker package to enable Block-based Backup support?

解説: (GoShiken メンバーにのみ表示されます)
An administrator already added a client "CLientA" This client has recently been assigned a second DNS named "ClientAB" When the backup ran, the following error is observed
"The client ClientAB is not in backup servers' clients list."
Use the simulator to resolve this issue

When you have finished, continue to the next question
正解:
The steps to resolve the issue of the client "ClientAB" not being in the backup server's clients list are as follows:
Verify the client name:
On the NetWorker server, open the NetWorker Management Console.
Go to the Clients tab.
Verify that the client "ClientA" is present in the list of clients.
Verify that the client "ClientAB" is not present in the list of clients.
Update the client name:
On the NetWorker server, open the NetWorker Management Console.
Go to the Clients tab.
Click on the ClientA.
In the Client Name field, update the name to "ClientAB"
In the Client Address field, enter the IP address or hostname of the client.
Click on the OK button to save the changes.
Re-schedule the backup
Go to the Clients tab.
Click on the ClientAB.
Go to the Schedules tab.
Remove the current schedule and create a new schedule for the client.
Select the appropriate schedule for the backup.
In the Save Set field, select the save set that you need to backup.
Click on the OK button to schedule the backup.
Monitor the backup process
Monitor the backup process to ensure that it is running successfully.
Check the logs for any errors.
How should a backup administrator install a virtual CloudBoost appliance on a VMware ESXi host?

解説: (GoShiken メンバーにのみ表示されます)
A backup administrator has installed a NetWorker Server on a Windows 2019 host. The installation finished successfully. When the NMC Launcher started and the backup server's name is specified as the NMC server, the following error is observed.
Unable to connect the NMC server
The administrator determined the NMC was not installed. What is the recommended action to resolve the issue?

解説: (GoShiken メンバーにのみ表示されます)
When deploying a new CloudBoost appliance, which command must be run to enable remote client mounts?

解説: (GoShiken メンバーにのみ表示されます)