DES-4122試験無料問題集（62題）「EMC Specialist - Implementation Engineer, PowerEdge 認定」

出題：1

A technician is creating a virtual disk in the iDRAC (2x 4 TB NL-SAS in RAID 1) to install Windows 2016 They manually boot to the OS installation media without using the Lifecycle Controller OS Deployment wizard Only the first 2048 GB on the virtual disk can be partitioned How should the technician obtain access to the remaining 2 TB (approximately) of storage?

A. Use the Lifecycle Controller OS Deployment Wizard to deploy the OS on this server

B. Use F2 to go into the BIOS, change the BIOS boot mode to UEFI, and try again

C. Upgrade to a newer version of the operating system

D. Delete the 4 TB virtual disk and create a virtual (boot) disk no larger than 2048 GB

正解：B 解答を投票する

出題：2

What are the default settings used when applying firmware and a configuration to a replaced part using the Lifecycle Controller?

A. Firmware Disabled
Configuration Apply only if firmware match

B. Firmware: Upgrade to latest available version
Configuration Apply always

C. Firmware Allow version upgrade only
Configuration: Disabled

D. Firmware: Match firmware of replaced part
Configuration Apply always

正解：D 解答を投票する

出題：3

For security reasons, the Dell EMC PowerEdge server power button must be disabled. Use the System Setup Utility in the simulator to disable the power button. When you have finished using the simulator, click Next.

A. A technician wants to

B. Send us your suggestion for this simulation task.

正解：B 解答を投票する

出題：4

What is the minimum number of components, beside the system board, required to POST?

A. 1 PSU and 1 CPU only

B. 1 PSU, 1 CPU, 1 DIMM, and PERC SAS controller

C. 1 PSU, 1 DIMM, and 1 CPU only

D. PSUs, CPUs, and DIMMs as configured in BIOS

正解：C 解答を投票する

出題：5

A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST, but then completed the POST and booted to the operating system. The user cannot remember the specific error and no entry was made in the error log relating to this error.
How can the technician find out what the error message was?

A. Access the Lifecycle Controller and view the last boot cycle video capture entry

B. Access the iDRAC and view the last boot cycle video capture entry

C. Export the Server profile and analyze for any POST errors

D. Reload the BIOS firmware

正解：B 解答を投票する

出題：6

What is a key distinction between 1DRAC8 and 1DRAC9?

A. iDRAC8 offers HTML5 based GUI

B. iDRAC9 offers HTML5 based GUI

C. iDRAC8 default credentials are customer orderable

D. iDRAC9 default credentials are root/calvin orderable only

正解：C 解答を投票する

DES-4122試験無料問題集「EMC Specialist - Implementation Engineer, PowerEdge 認定」