DES-5121試験無料問題集「EMC Specialist - Implementation Engineer, Campus Networking 認定」
Switch-1(config)# interface tengigabitethernet 1/0/1
Switch-1(config)# switchport mode access
Switch-1(config)# switchport trunk allowed vlan 10, 20
Switch-1(config)#
Switch-1(config)# interface tengigabitethernet 1/0/3
Switch-1(config)# switchport mode access
Switch-1(config)# switchport access vlan 10
Switch-2(config)# interface tengigabitethernet 1/0/2
Switch-2(config)# switchport mode trunk
Switch-2(config)# switchport trunk allowed vlan 10, 20
Switch-2(config)#
Switch-2(config)# interface tengigabitethernet 1/0/6
Switch-2(config)# switchport mode access
Switch-2(config)# switchport access vlan 20
A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.
Based on the switch output shown in the exhibit, what is the reason for the communication issue?
Switch-1(config)# switchport mode access
Switch-1(config)# switchport trunk allowed vlan 10, 20
Switch-1(config)#
Switch-1(config)# interface tengigabitethernet 1/0/3
Switch-1(config)# switchport mode access
Switch-1(config)# switchport access vlan 10
Switch-2(config)# interface tengigabitethernet 1/0/2
Switch-2(config)# switchport mode trunk
Switch-2(config)# switchport trunk allowed vlan 10, 20
Switch-2(config)#
Switch-2(config)# interface tengigabitethernet 1/0/6
Switch-2(config)# switchport mode access
Switch-2(config)# switchport access vlan 20
A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.
Based on the switch output shown in the exhibit, what is the reason for the communication issue?
正解：A
解答を投票する
N4032F#show interfaces status
N4032F#show interfaces port-channel 1
Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
N4032F#
A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.
Based on the exhibit, why is only one link active?
N4032F#show interfaces port-channel 1
Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
N4032F#
A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.
Based on the exhibit, why is only one link active?
正解：B
解答を投票する
After setting up the VoIP configuration, a network administrator issues the following commands with the results shown:
console# show voice vlan
Administrative Mode...........................Enable
console# show voice vlan it gi 1/0/2
Interface........................................Gi1/0/2
Voice VLAN Interface Mode...............Enabled
Voice VLAN ID...............................10
Voice VLAN COS Overwrite...............False
Voice VLAN DSCP Value...................46
Voice VLAN Port Status.....................Enabled
Voice VLAN Authentication................Disabled
Based on this information, what is the Layer 3 QoS value?
console# show voice vlan
Administrative Mode...........................Enable
console# show voice vlan it gi 1/0/2
Interface........................................Gi1/0/2
Voice VLAN Interface Mode...............Enabled
Voice VLAN ID...............................10
Voice VLAN COS Overwrite...............False
Voice VLAN DSCP Value...................46
Voice VLAN Port Status.....................Enabled
Voice VLAN Authentication................Disabled
Based on this information, what is the Layer 3 QoS value?
正解：A
解答を投票する