HPE0-S59試験無料問題集「HPE Compute Solutions 認定」

A. Both modules are located in different frames for redundancy

B. interconnect modules are installed in interconnect bays 1 and 4

C. For an uplink set, ports from different modules can be selected

D. An additional license is required to change the enclosure count

A. The customer can install up to 12 HPE Synergy 480 compute nodes per frame.

B. The customer must create at least five logical enclosures for this setup.

C. To manage 15 frames, additional HPE Composers are required.

D. If properly cabled, any compute node can access any HPE D3490 storage module

A. It can be used to determine whether the latest milestone HPE OneView edition is currently installed.

B. It can be used to examine the firmware version installed on compute nodes and compliance with HPE OneView version.

C. It can be used to verify compatibility of a given Synergy Service Pack with a specific version of HPE OneView.

D. It can be used to evaluate the health of an HPE OneView appliance before proceeding with an appliance update.

A. If the D3940 module is imported in a managed state that allows volume provisioning.

B. If the D3940 storage module is properly licensed through the HPE OneView interface.

C. If the SAS logical interconnect is a part of the logical enclosure and has a healthy state.

D. If there is at least one iSCSI network configured that will provide access to the module.

A. HPE Composer 2 can support more than the maximum 21 frames that are supported with HPE Composer 1 and HPE OneView.

B. HPE Composer 1 cannot support remote frames, which doubles the configuration and management procedures effort

C. HPE Composer 2 provides access to 105 interface that can be used for full management of HPE Composer 2 remotely

D. HPE Composer 1 running HPE OneView 5 2 or later can support only 12 frames within a single management nog

A. When a customer needs each port associated with a given uplink set to be 100Gb/s.

B. When a customer needs the ability to create a network dedicated to a single compute node.

C. When a customer needs additional network security by limiting traffic flow for the given network.

D. When a customer needs a heartbeat network between two compute nodes for building a cluster.

A. It can disable link aggregation groups or stacking ports that have gone down and come up in quick succession.

B. It allows an administrator to suppress excessive inbound multicast, broadcast, and DLF packets.

C. It allows the creation of LACP groups on the upstream switch that span multiple HPE Synergy Virtual Connect modules.

D. It allows configuration of hardware Layer 2 switching behavior of multicast traffic to optimize network resource usage.

A. It is supported only for logical enclosures with at least three frames

B. It provides an ability to select and update one side of the Interconnect topology at a time

C. It provides the ability to install an older firmware version than currently Installed In the interconnect

D. It allows all the interconnect modules to be activated manually at the same time.

A. nPars are supported only with 3rd Generation Intel Xeon Scalable Processors

B. Chassis in the same nPar can have different CPU configuration

C. Chassis in the same nPar can have different memory configuration

D. Rack Management Controller is required Tor nPar configuration