A. Create an HPE OneView backup, either manually or to the remote location.
B. Disable HPE Remote Support at the HPE OneView appliance level.
C. Create a support dump for the appliance and for all managed logical interconnects.
D. Put all servers managed through HPE OneView into maintenance state.
A. RoCE networks require Virtual Connect SE 32Gb FC Modules.
B. RoCE networks cannot be configured when Virtual Connect modules are used.
C. RoCE networks are not supported with HPE BladeSystem
D. RoCE networks are supported only when PVLANs are enabled.
A. Volumes created on the first storage pool cannot use data reduction technologies
B. Both storage pools are in a managed state and can be used for volume provisioning
C. HPE OneView can be used to configure volume replication between these pools
D. Both storage pools have a license applied that enables management of these pools
A. Ethernet connection is configured to boot from PXE
B. All connections within the server profile are using physical IDs
C. LACP on downlinks is configured for Ethernet connection
D. Storage array is connected directly to an HPE Synergy frame
A. Users will be able to select storage pool during volume creation
B. A volume created using this template will not support deduplication
C. Users will be able to change sharing type and volume capacity
D. A volume created using this template mil not support snapshots
A. Storage Array
B. Master Module
C. Compute Module
D. Logical Enclosure
A. Rack Management Controller (RMC)
B. only the base chassis from the complex
C. Baseboard Management Controller (BMC)
D. all nPARs created within the complex
A. Disable HPE Remote Support at toe HPE OneView appliance level
B. Run the Update Readiness checker tool to evaluate HPE OneView health status
C. Put all servers managed through HPE OneView to maintenance state
D. Create a support dump for the appliance and for all managed logical interconnects
A. HPE Synergy cannot be deployed remotely, as Initial setup must be performed using a local console connection.
B. HPE Synergy can be configured remotely through a secure connection to the FLM if this option was enabled In the factory.
C. Remote HPE Synergy Installation can be done only if an additional set of the services was purchased together with hardware platform.
D. Remote HPE Synergy setup is possible if HPE Composer 2 is used and a DHCP server Is available in the management network.
A. Users will be able to select storage pool during volume creation.
B. A volume created using this template will not support snapshots.
C. A volume created using this template will support deduplication.
D. Users will be not able to change sharing type and volume capacity.
