HPE6-A48試験無料問題集「HP Aruba Certified Mobility Expert Written 認定」

ページ: 1 / 10
トータル 75 問
完全版を入手する
A financial institution contacts an Aruba partner to deploy an advanced and secure Mobility Master (MM)-Mobility Controller (MC) WLAN solution in its main campus and 14 small offices/home offices (SOHOs). Key requirements are that users at all locations, including telecommuters with VIA, should be assigned roles with policies that filter undesired traffic. Also, advanced WIPs should be enforced at the campus only.
These are additional requirements for this deployment:
RAPs should ship directly to their final destinations without any pre-setup and should come up with the right configuration as soon as they get Internet access.

Activate should be configured with devices MACs, serial numbers, and provisioning rules that redirect them to the standalone VMC at the DMZ

Users should be able to reach DNS, FTP, Web and telephone servers in the campus as well as send and receive IP telephone calls to and from the voice

10.1.50.0/24 segment.
Local Internet access should be granted.

Refer to the exhibit.

Refer to the scenario and the exhibit.

The standalone VMC will act as a VPN Concentrator of the RAPs. The network administrator configures the Standalone VMC with a pool of addresses and the SOHOs AP Group from the MM.
Which additional steps must the network administrator perform to allow the RAPs to terminate their IPSec tunnels and associate to the Standalone VMC?

Refer to the exhibit.

A network administrator wants to configure an 802.1x supplicamt for a wireless network that includes the following:
AES encryption

EAP-MSCHAP v2-based user and machine authentication

Validation of server certificate in Microsoft Windows 10

The network administrator creates a WLAN profile and selects the change connection settings option. Then the network administrator changes the security type to Microsoft: Protected EAP (PEAP), and enables user and machine authentication under Additonal Settings.
What must the network administrator do next to accomplish the task?

Refer to the exhibit.

A network administrator deploys a new Mobility Master (MM)-Mobility Controller (MC) network. To test the solution, the network administrator accessess some of the AP consoles and statistically provisions them. However, these APs do not propagate the configured SSIDs. The network administrator looks at the logs and sees the output shown in the exhibit.
Which actions must the network administrator take to solve the problem?

During master controller redundancy and failover, these steps occur:
1. Master 1 acts as the primary master and it goes down, therefore, Master 2 takes over as primary.
2. Master 1 comes back up again (reboots).
3. Master 2 continues to be the active master.
Based on this scenario, how is master redundancy configured on the controller?

A point venture between two companies results in a fully functional WLAN Aruba solution. The network administrator uses the following script to integrate the WLAN solution with two radius servers, radius1 and radius2.

While all users authenticate with [email protected] type of credentials, radius1 has user accounts without the domain name portion.
Which additional configuration is required to authenticate corp1.com users with radius1 and corp2 users with radius2?

A network engineer plans for a corporate WLAN that must support 802.1X authentication. Based on HA best practices, the engineer plans to deploy a 7210 controller as an active local controller and terminate 100 CAPs in the primary data center. In a secondary data center, the engineer plans to deploy two 7030 controllers as standby local controllers and terminate 20 CAPs. The engineer notices that there is unstable and unpredictability transmission latency between the two sites.
What should be the engineer do to configure this solution according to HA best practices?

A network administrator wants to receive a major alarm every time a controller or an Aruba switch goes down for either a local or an upstream device failure.
Which alarm definition must the network administrator create to accomplish this?

Several users are connected to the same WLAN and want to play the same multicast-based video stream. The network administrator wants to reduce bandwidth consumption and at the same time increase the transmit rate to a fixed value for WMM marked video streams in a large-scale network. Broadcast Multicast Optimization (BCMCO) is already on.
Which two configuration steps does the network administrator have to perform to optimize the multicast transmissions? (Select two.)

ページ: 1 / 10
トータル 75 問