H12-811-ENU試験無料問題集「Huawei HCIA-Datacom V1.0 認定」

Trunk ports can allow multiple VLANs to pass, including VLAN4096. ()

Protocol Priority Switch A. and Switch B. adopt LACP mode link aggregation, and all interfaces join the link aggregation group.
At the same time, set the maximum number of active ports to 3. Then which port of switch A is not an active port? ()

An AR2200 router needs to restore the initial configuration, which of the following operations are necessary? ()*

In the VRP interface, use the command delete vrpcfg.zip to delete a file. The file must be emptied in the recycle bin to completely delete the file. ()

The administrator has configured the AR2200. Which of the following descriptions about the configuration information is correct ()

What is the maximum negotiation rate supported by the IEEE802.11g standard? ()

The following description of static and dynamic routing is wrong ().

The configuration information of a certain router is shown in the figure. Which of the following statements are correct? () (Single-choice question)
#
aaa
authentication-scheme default
authentication-scheme huawei
authentication-mode radius
authorization-scheme default
authorization-scheme huawei
accounting-scheme default
domain default
domain default admin
domain huawei
authentication-scheme huawei
authorization-scheme huawei
local-user huawei password cipher 123456
local-user huawei@huawei password cipher 654321
#

The election of the root switch in STP only compares the priority of the switch, while in RSTP, the priority of the switch is compared with the MAC address at the same time. ()

How many types of data flows with different service levels can be marked based on MPLS labels? ()

After OSPF is configured on the two routers, the administrator configures commands on RTA.
Which of the following descriptions is correct? ()

正解:A,B,C 解答を投票する
The classic network forwarding method is based on router routing table forwarding. The forwarding method of OpenFlow switches is based on flow table forwarding. Which of these two forwarding methods are correct? ()*

正解:A,C,D 解答を投票する
What is correct about the SNMP protocol? ()

What is the total length of an IPv6 address in bits? ()

The router receives a data packet with a destination IP address of 11.0.12.1 from host A. After this data packet is forwarded by the router, what are the destination MAC. and destination IP? ()

An ACL rule is as follows: Which of the following IP addresses can be matched by permit rules? () rule5per mit ip source10.0.1.00.0.254.255*

The Priority field in the VLAN tag can identify the priority of the data frame. What is the scope of this priority? ()

Which of the following port states is not included in the RSTP protocol? ()

As shown in the figure. All four switches are running $TP. Various parameters are set to default values. If the GO/0/2 port of switch C is blocked and cannot send configuration BPDUs through this port, how long will it take for the blocked port in the network to enter the forwarding state? () (Single-choice question)