H35-460試験無料問題集「Huawei HCIA-5G-RAN V1.0 認定」

ページ: 1 / 12
トータル 221 問
完全版を入手する
In the Sub 3G band, the maximum number of SSBs in NR is 16.

NR began to support the base station version of the UBBPg half-width board, which of the following versions started?

In general, which of the following base station equipment commissioning methods causes the longest DownTime?

Regarding the NR slot structure, what are the correct terms described below?

gNodeB requires two IP addresses to the same destination with the same destination mask and the same route priority cannot be the same.

What is the broadcast period of MIB messages in NR?

What compression ratios are supported by the CPRI port of 5G RAN2.1 gNodeB?

正解：A,B,C 解答を投票する
The NR neighboring cell measurement event of the UE adopts B1, and the corresponding RSRP threshold value 35, which is the true level value?

Which of the following is the default near-end maintenance address for gNB UMP boards?

What is wrong with the description of AAU5613?

Which of the following are required modules for gNodeB?

正解：B,C,D 解答を投票する
5G RAN 2.0 version gNodeB adds which MML command is used in DU cells?

If the main control board UMPT uses a 10Gbps optical module when the NR base station is turned on, the ETHPORT of GTRANSPARA must be configured to 10Gbps and cannot be configured to slow down.

The rate mode of the gNodeB Ethernet port needs to be consistent with the docking interface.

VSWR testing on U2000 will cause business interruption and prohibit operation when business is busy.

gNodeB passes Ethernet frames with the TAG flag, called VLAN tagged frames.

What is the maximum number of UBBPwfl boards supported by BBU5900?

To delete the original default data before configuring gNodeB, you need to complete the initialization of the base station configuration.

Which of the following parameters is related to the frequency domain position of the PBCH DMRS?

ページ: 1 / 12
トータル 221 問