A. 1. with a screwdriver, pop out the MSR hole plugs on the left side of the display2.align theMSR tabs into the holes and slide down so that the MSR is flush against the display3.route the MSR cable in the groove and attach it to the port on the rear connector panel4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
B. 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display3.route theMSR cable in the groove and attach it to the back side of the display4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
C. 1. open the bezel and remove the MSR plugs2.with the bezel open, position the MSR tabs in the holes3.connect the MSR cable to the connector on the operator card4.close and secure the bezel
D. 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display3.remove the tower center cover to access the MSR connector 4.route the MSR cable in the groove on the back of the display and attach it to the connector in the center of the system
A. water
B. chlorine
C. mild liquid class cleaner
D. isopropyl alcohol
A. at the front of the system, directlyunderneath the front cover
B. in the center of the system, underneath the center tower cover
C. at the rear of the system, just above the power supply
D. at the rear of the system, behind the I/O tailgate cover
A. nothing; this is normal for the type of power supply used
B. replace the power supply fan
C. ensure that the hard disk drive fan and the processor fan are plugged into the system board
D. using a voltmeter; verify that the power supply output voltage is +12.0 V
A. boot from the IBM Diagnostics for POS Systems and Peripherals and run the BIOS update utility
B. attach the IBM SurePOS 5x5 to the Internet and download the BIOS version from theIBM Retail Store Solutions Web site
C. load it from a USB attached floppy drive containing a diskette with the latest BIOS on it
D. run the Setup Utility and select Update BIOS
A. Microsoft Windows XP Professional
B. Microsoft Windows Embedded for Point of Service
C. IBM 4690 Operating System
D. Microsoft Windows 2000
E. IBM PC DOS 2000
