JN0-363試験無料問題集「Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP) 認定」

ページ: 1 / 15
トータル 293 問
完全版を入手する
You are adding nonforwarding route reflectors to your network. Which three actions ensure that VPN routes are advertised properly? (Choose three.)

正解：B,C,D 解答を投票する
Click the Exhibit button.

You must create a static route on Router-A to the 10.10.5.0/24 network using 10.10.3.2 as the next hop.
Referring to the exhibit, which configuration accomplishes this task?

What are two benefits of using an OSPF designated router (DR)? (Choose two.)

You confirm that the R2 and R3 routers are receiving a BGP route to the 203.0.113.0/24 network, but both routers display the route as hidden. Referring to the exhibit, which two actions solve this problem? (Choose two.)

Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSA ASBR into the backbone?

According to Juniper Networks, what are two reasons to peer using loopback addresses when configuring BGP? (Choose two.)

Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP session with the ISP?

You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the locally connected CE router's interface. The address of the interface is 192.168.1.1; the VPN routing-instance is named VPN-A.Which command will accomplish this task?

Which statement is true about the operation of Layer 2 VPNs?

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Which packet type does the router use to request up-to-date link-state information?

You want to make use of the nonstop active routing (NSR) feature.
Which complementary feature must also be enabled?

解説: (GoShiken メンバーにのみ表示されます)
You have been asked to provision a service provider's network to accommodate Layer 3 VPNs as defined in RFC 4364.Which three tasks must be performed before the provider network is ready to carry VPN traffic? (Choose three.)

正解：A,B,C 解答を投票する
Click the Exhibit button.

Referring to the exhibit, which statement is correct?

Click the Exhibit.

On an MX Series device, you must enable routing between VLANs 100,200, and the Internet ge-5/1/0, and ge-5/1/2 are bundled into interface ae3. Ge-5/1/4, and ge-5/1/5 are bundles into interface ae2. Both AE bundles trunk VLANs 100 and 200.
In this scenario, what is the correct configuration snippet for VLAN 100?

Referring to the exhibit, you have an established RSVP LSP between R1 and R4 when you experience a link failure between R2 and R3. Which two statements are correct? (Choose two.)

What are three ways to configure IPv6 addresses in your network? (Choose three.)

正解：B,C,D 解答を投票する
Which statement correctly describes a characteristic of IPv6 unicast addressing?

Your customer would like to forward traffic using DLCI 600 and maintain Layer 2 information across a VPN.Which solution will meet these requirements?

By default, the Junos OS advertises which address(es) in LDP forwarding equivalency class (FEC) messages?

ページ: 1 / 15
トータル 293 問