JN0-682試験無料問題集（155題）「Juniper Data Center, Professional (JNCIP-DC) 認定」

出題：1

Which EVPN router type prevents BUM traffic from looping back to a multihued host?

A. IP prefix route

B. Ether auto discovery route

C. Inclusive multicast-Ethernet tag route

D. Ethernet segment router

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

In an EVPN multicast environment, which two route types facilitate IGMP join and IGMP leave behavior for multihomed sites? (Choose two.)

A. type-8

B. type-3

C. type-7

D. type-4

正解：A,C 解答を投票する

出題：3

What are three functions supported by the Contrail Command user interface?

A. Enabling VM-to-BMS bridging

B. Integrated syslog collector

C. Onboarding of an IP fabric

D. Configuring management domains

E. Creating virtual network

正解：B,D,E 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

The configuration shown in the exhibit is intended to set up assisted replication but will not commit. Which action will create a valid configuration in this situation?

A. Change the replicator inet address to 192.168.100.101.

B. Change the 10.0 address to 192.168.100.1 primary.

C. Delete replicator inet 192.168.100.1.

D. Change the replicator inet address to 192.168.100. 51.

正解：A 解答を投票する

出題：5

Which statement is true about a Data center interconnect over an IP network?

A. Layer 2 data must be encapsulated.

B. Layer 2 data must traverse an MPLS LSP.

C. Layer 2 data must traverse a point-to-point

D. Layer 3 data must be encapsulated

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

Referring to the exhibit, which two statements are correct? (Choose two.)

A. An OTT data center interconnect is in use.

B. Switch01 is a spine device.

C. Seamless EVPN VXLAN stitching is in use.

D. Switch01 is a leaf device.

正解：C,D 解答を投票する

出題：7

Refer to the exhibit.

Referring to the exhibit, which two statements are correct in a seamless EVPN-VXLAN stitching DCI design? (Choose two.)

A. The 00:21:22:23:24:25:26:27:28:22 value represents the interconnect ESI.

B. The 10.1.1.2 host is reachable in a remote data center POD.

C. The 10.1.1.1 host is reachable in a remote data center POD.

D. The 00:21:22:23:24:25:26:27:28:22 value represents the local ESI.

正解：A,C 解答を投票する

出題：8

Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load- share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B.

Which two actions must be performed to accomplish this task? (Choose two.)

A. Use advertise inactive

B. Use multihop

C. Use a load-balancing policy applied to the forward table

D. Use multipath multipath-As

正解：C,D 解答を投票する

出題：9

You need to add perimeter security to the network shown in the exhibit. All traffic must be inspected for attacks. The edge routers are using all available ports. Your solution must maintain both port and device resiliency.

In this scenario, which design would satisfy these requirements?

A. one-arm SRX Series chassis cluster

B. one-arm SRX Series device using LAG

C. inline SRX Series chassis cluster

D. inline SRX Series device using LAG

正解：C 解答を投票する

出題：10

An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. Host1 is a bare metal server, and is dual-homed to the network. The IP addresses 10.1.1.1/24 and 10.1.1.2/24 are assigned to the same physical NIC, and no virtualization is configured on the server.

In this scenario, which two statements are true? (Choose two.)

A. The ESI assigned to the host1 link must be the as the ESI assigned to the leaf2 host1 link.

B. Traffic from IP address 10.1.1.1/24 must traverse the VXLAN network to reach IP address 10.1.1.2/24

C. The MAC address associated with 10.1.1.1/24 and 10.1.1.2/24 will be same when advertised to leaf3.

D. The connection host1 to devices leaf1 and leaf2 must be configuration a LAG.

正解：A,D 解答を投票する

JN0-682試験無料問題集「Juniper Data Center, Professional (JNCIP-DC) 認定」