JN0-683試験無料問題集（67題）「Juniper Data Center, Professional (JNCIP-DC) 認定」

出題：1

You are deploying a new network lo support your Al workloads on devices that support at least 400 Gbps Ethernet. There is no requirement for any Layer 2 VLANs in this network. Which network architecture would satisfy this requirement?

A. an IP fabric using EBGP

B. an IP fabric using the EVPN-MPLS architecture

C. an IP fabric using PIM-SM to signal VXLAN overlay

D. an IP fabric with an EVPN-VXLAN architecture

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：2

You want to convert an MX Series router from a VXLAN Layer 2 gateway to a VXLAN Layer 3 gateway for VNI 100. You have already configured an IRB interface. In this scenario, which command would you use to accomplish this task?

A. set bridge-domains VLAN-100 routing-interface irb.100

B. set vlans VLAN-100 13-interface irb.100

C. set protocols ospf area 0.0.0.0 interface irb.100 passive

D. set protocols isis interface irb.100 passive

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：3

You are implementing VXLAN broadcast domains in your data center environment. Which two statements are correct in this scenario? (Choose two.)

A. A VXLAN packet does not contain a VLAN ID.

B. The VNI must match the VLAN tag to ensure that the remote VTEP can decapsulate VXLAN packets.

C. Layer 2 frames are encapsulated by the source VTEP.

D. The VNI is a 16-bit value and can range from 0 through 16.777.215.

正解：A,C 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：4

Which parameter is used to associate a received route with a local VPN route table?

A. route-target community

B. VLAN ID

C. route-distinguisher

D. VNI

正解：A 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：5

Exhibit.

Connections between hosts connected to Leaf-1 and Leaf-2 are not working correctly.
Referring to the exhibit, which two configuration changes are required to solve the problem? (Choose two.)

A. Configure the set switch-options service-id 1 parameter on Leaf-2.

B. Configure the set switch-options vrf-target target: 65000:55 parameter on Leaf-2.

C. Configure the setswitch-options route-distinguisher 192.168.100.51:2 parameter on Leaf-1.

D. Configure the setswitch-options vtep-source-interface100. 0 parameter on Leaf-1.

正解：A,B 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：6

You are deploying an IP fabric with an oversubscription ratio of 3:1.
In this scenario, which two statements are correct? (Choose two.)

A. The oversubscription ratio remains the same when you add leaf devices.

B. The oversubscription ratio decreases when you add leaf devices.

C. The oversubscription ratio remains the same when you remove leaf devices.

D. The oversubscription ratio increases when you remove leaf devices.

正解：A,D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：7

You are asked to build redundant gateways in your EVPN-VXLAN environment, but you must conserve address space because these gateways must span across seven PES. What should you implement on the PEs lo satisfy these requirements?

A. Use IRB interfaces with different IP addresses and the same VGA.

B. Use IRB interfaces with the same IP and VGA.

C. Use IRB interfaces with the same IP address and different MAC addresses.

D. Use IRB interfaces with the same IP and MAC address.

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

JN0-683試験無料問題集「Juniper Data Center, Professional (JNCIP-DC) 認定」