NACE-CIP2-001試験無料問題集（100題）「NACE Coating Inspector Level 2 認定」

出題：1

Which concrete smoothing technique involves scrubbing a mixture of cement mortar over the concrete surface using ai cement sack, gunny sack, or sponge rubber float?

A. Sacking

B. Stoning

C. High-pressure water washing

D. Acid etching

正解：A 解答を投票する

出題：2

Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

A. Gathering

B. Transmission

C. Distribution

D. Midstream

正解：C 解答を投票する

出題：3

In the event of a conflict between the Product Data Sheet and the Specification:

A. It is up to the Applicator to decide which one to follow

B. It is up to the Inspector to decide which one to follow

C. The Product Data Sheet prevails

D. The Specification prevails

正解：D 解答を投票する

出題：4

You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:

A. Advise the other inspector he is using an incorrect method

B. Review the specification with the other inspector to see what method was specified

C. Advise your QC Manager to change the ITP to the use of the salt smart meter

D. Redo the pre-cleaning based on the other inspectors results

正解：B 解答を投票する

出題：5

Non-Conformance Reports are designed to:

A. Elevate the status of the Inspector

B. Punish the Contractor for substandard work

C. To identify items that do not meet the specification requirements

D. Assist the Owner in negotiating credits from the Contractor

正解：C 解答を投票する

出題：6

Coating Surveys are legally required:

A. On commercial marine vessels and offshore platforms

B. On food and beverage vessels and can linings

C. On water tanks and potable water pipelines

D. On high pressure gas lines and fireproofed structures

正解：A 解答を投票する

出題：7

When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:

A. A very high reading

B. Cold flow or creep

C. A very low reading

D. No difference from any other coating

正解：B 解答を投票する

出題：8

You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

A. Risk of acid or caustic splashes

B. Risk of chemical exposure

C. Risk of skin

D. a), b), and c)

正解：D 解答を投票する

出題：9

You are the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no individual gauge reading shall be below a certain value.
As this is not part of the standard you should:

A. Request clarification from the specifier

B. Enforce the additional requirement

C. Call your supervisor

D. Ignore the additional requirement

正解：B 解答を投票する

出題：10

Dehumidification is defined as the removal of moisture vapor from the air to

A. lower its temperature

B. provide worker comfort.

C. lower its dew point,

D. raise its relative humidity.

正解：C 解答を投票する

NACE-CIP2-001試験無料問題集「NACE Coating Inspector Level 2 認定」