NCM-MCI-5.20試験無料問題集（166題）「Nutanix Certified Master - Multicloud Infrastructure (NCM-MCI) 5.20 認定」

出題：1

An administrator is unable to discover a Nutanix-hosted iSCSI Block device allocated to a bare-metal host.
What is causing this issue?

A. External Host IP address is not in FileSystem Whitelist

B. Jumbo Frames has not been configured on the switch

C. External client access has not been enabled for the host

D. Network segmentation has not been enabled

正解：A 解答を投票する

出題：2

An administrator responsible for a VDI environment needs to investigate reports of slow logins. The administrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count on all of the VDI VMs.
What are two impacts on the cluster? (Choose two.)

A. Increasing CPU counts will decrease memory utilization

B. Increase memory utilization%

C. Increase CPU ready%

D. Increase CPU utilization%

正解：A,B 解答を投票する

出題：3

Refer to the exhibit.

An administrator notices a critical alert on the Metro Availability Protection Domain What is causing this alert?

A. vSphere moved VMs to the remote container, and the VMs must be moved back.

B. Metro Availability Protection domain is active on the remote site.

C. VMware Site Recovery Manager is handling a failover event

D. Metro Availability did not fail over and caused an outage.

正解：B 解答を投票する

出題：4

An administrator receives an error indicating that the CVMs in the cluster are not syncing to any NTP servers. An investigation of the issue finds:
* The NTP servers are configured in Prism
* The time on all CVMs is the same
* Both the CVMs and AHV hosts are configured for the UTC time zone
Which two steps can be taken to troubleshoot this issue? (Choose two.)

A. Restart the chronos service on all CVMs.

B. On a CVM. run the command a Hash ntpq -pn.

C. Restart genesis on all CVMs.

D. Confirm that the NTP servers are reachable from the CVMs.

正解：B,D 解答を投票する

出題：5

An administrator needs to expand a cluster based on AHV and running on Nutanix G5 hardware with a new Nutanix G7 system. The cluster is running AOS 5.10 but the operation fails when expanding the cluster. AOS is running on the new system. There are no issues discovering the node.
Why is the operation failing?

A. EVC needs to be configured before cluster expansion

B. G7 hardware cannot be added to a G5 cluster.

C. Foundation software has not been updated on the cluster.

D. AOS version running on G7 is older than the version on the cluster.

正解：D 解答を投票する

出題：6

An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:

What is causing this issue?

A. Incorrect link speeds on the switch

B. A physical layer network problem

C. A misconfigured bond

D. The interface is incorrectly configured with Jumbo Frames

正解：D 解答を投票する

解説: (GoShiken メンバーにのみ表示されます)

出題：7

How should an administrator view the storage consumed by the recycle bin?

A. In the Diagram or Table view on the Storage dashboard

B. On the storage Overview dashboard

C. On the storage Summary Widget on the Prism Dashboard

D. In the Cluster Details Page of the cluster setting

正解：A 解答を投票する

出題：8

An administrator needs to take a single node down for maintenance. Which two steps should the administrator take? (Choose two)

A. Verify the data resiliency status of the cluster.

B. Reclaim the licenses to the Nutanix Support Portal.

C. Make sure Auto Evacuation is enabled

D. Shut down or live migrate all VMs off of the node.

正解：A,D 解答を投票する

出題：9

An administrator needs to expand a nutanix cluster that is tagging the network traffic at the CVM and AHV level, however the administrator doesn't remember the configured VLAN ID.
Which AHV command can the administrator run to find the correct VLAN ID?

A. ifconfig

B. acli

C. ovs-vsctl

D. manage_ovs

正解：C 解答を投票する

出題：10

An Administrator is concerned that a VM on a hybrid Cluster with 8Gb RAM and 4 vCPU is performing poorly.
An Analysis of the VM indicates that CPU Utilization is at 50% ,memory utilization is at 30% , and disk latency is at 18ms.
What can the administrator do to improve performance?

A. add 4GB RAM

B. Increase vDisk Size

C. Enable FLash Mode

正解：A 解答を投票する

NCM-MCI-5.20試験無料問題集「Nutanix Certified Master - Multicloud Infrastructure (NCM-MCI) 5.20 認定」